深圳科茂隆提供AT89S58芯片解密服务,科茂隆承诺以最合理的价格、100%的成功率及最短的项目周期为客户提供优质服务.以下提供AT89S58芯片解密部分技术参数,以供参考.
AT89S58 Features 
• 80C51 Compatible
– 8051 Instruction Compatible
– Six 8-bit I/O Ports (64 Pins or 68 Pins Versions)
– Four 8-bit I/O Ports (44 Pins Version)
– Three 16-bit Timer/Counters
– 256 Bytes Scratch Pad RAM
– 9 Interrupt Sources with 4 Priority Levels
• Integrated Power Monitor (POR/PFD) to Supervise Internal Power Supply (AT89S64Only)
• ISP (In-System Programming) Using Standard VCC Power Supply
• 2048 Bytes Boot ROM Contains Low Level Flash Programming Routines and a DefaultSerial Loader
• High-speed Architecture
– In Standard Mode: 40 MHz (Vcc 2.7V to 5.5V, both Internal and external code execution)   60 MHz (Vcc 4.5V to 5.5V and Internal Code execution only)
– In X2 mode (6 Clocks/machine cycle)  20 MHz (Vcc 2.7V to 5.5V, both Internal and external code execution)  30 MHz (Vcc 4.5V to 5.5V and Internal Code execution only)
• 16K/32K/64K Bytes On-chip Flash Program/Data Memory
– Byte and Page (128 Bytes) Erase and Write
– 100k Write Cycles
• On-chip 1792 bytes Expanded RAM (XRAM) for AT89S64, 768 Bytes for AT89S54/58
– Software Selectable Size (0, 256, 512, 768, 1024, 1792 Bytes)
– 768 Bytes Selected at Reset for AT89S64
– 256 Bytes Selected at Reset for AT89S54/58
• Dual Data Pointer
• Variable Length MOVX for Slow RAM/Peripherals
• Improved X2 Mode with Independent Selection for CPU and Each Peripheral
• 8-bit Clock Prescaler
• 16-bit Programmable Counter Array
– High Speed Output
– Compare/Capture
– Pulse Width Modulator
– Watchdog Timer Capabilities
• Asynchronous Port Reset
• Full-duplex Enhanced UART with Dedicated Internal Baud Rate Generator
• Low EMI (Inhibit ALE)
• Hardware Watchdog Timer (One-time Enabled with Reset-Out), Power-off Flag
• Power Control Modes: Idle Mode, Power-down Mode
• Single Range Power Supply: 2.7V to 5.5V
• Industrial Temperature Range (-40 to +85°C)
• Packages: PLCC44, PDIL40
AT89S58特点
·80C52完全兼容；- 8051指令兼容
- 6个8位I / O端口（64针或68引脚版本）- 4个8位I / O端口（引脚44版）
- 3个16位定时器/计数器；- 256字节便签RAM
- 9个中断源，4个优先级；集成的电源监控（葡萄牙/ PFD的）监督内部电源（AT89S64Only）
·ISP（在系统编程）使用标准VCC电源；2048字节的引导ROM包含低级别闪存编程程序和DefaultSerial装载机
·高速架构； 在标准模式：40兆赫（2.7V至5.5V的VCC，内部和外部代码执行）60兆赫（4.5V至5.5V的VCC和内部代码执行只）
- 在X2方式（6时钟/机器周期）20兆赫（2.7V至5.5V的VCC，内部和外部代码执行），30兆赫（4.5V至5.5V的VCC和内部代码只）
·16K/32K/64K字节片上闪存程序/数据存储器；- 字节和页（128字节）的擦除和写入
- 100K的写周期；片上1792字节扩展RAM（内XRAM）为AT89S64，768 AT89S54/58字节
- 软件可选择尺寸（0，256，512，768，1024，1792字节）；- 768字节选定复位AT89S64
- 256字节选定复位AT89S54/58；双数据指针
·变慢速内存/外设长度的MOVX；改进x2模式具有自主CPU和每个外设的选择
·8位预分频器的时钟；16位可编程计数器阵列；- 高速输出
- 比较/捕获；- 脉宽调制器；- 看门狗定时器功能
·异步端口复位；全双工加强与专用的内部UART的波特率发生器
·低EMI；硬件看门狗定时器（一次性使用复位输出启用），断电标志
·电源控制模式：空闲模式，掉电模式；单电源范围：2.7V至5.5V
·工业级温度范围（-40至+85 ° C）；封装：PLCC44脚，PDIL40